Flock is enrolled in the voluntary Scrapie Free Certification Program (SFCP) - Export Category - Enrolled: 2012-10-30
Flock is OPP negative.
Reservation & Contract Form
News

 Proven Ram - Mac is for sale.  Click on his photo for more information.

Our 2019 lambs have started arriving. The breeding pairs used can be seen here. Photos of the lambs and the flock are posted on facebook just about every day.

Make your reservations soon and if we sell out of this year's lambs, it's never too early to reserve for next year.

Roving is being processed on a continual basis from our 2018 shearing. Contact me and/or check out the Shoppe for roving, yarn, and handmade items.



Fort Fence
What we refer to as our "Fort Fence" to go along with our military theme is another solution I came up with to use as a temporary fence when we need additional pasture area for The Babydolls. It goes up in a flash and we don't have to pound poles into rocky ground.
Note: Click on the color images to enlarge them.
fortfence.jpg
tripod.jpg
tripodcloseup.jpg
Items Needed: items available at Southern States, Tractor Supply, Lowe's, Home Depot type stores.
3 - 5.5' T-poles for each "tee pee" — approximately $4.75 each T-post
? - 16' feedlot panels — approximately $20.00 each feedlot panel measurements
feedlot panel

? rope — I used some I already had on hand
? - double-sided hooks — approximately $1.50 each double-sided snap hook
instructions for tripod lashing
TRIPOD LASHING


Construction:
  1. Figure out how many tripods you'll need to make. Each end of the "fence" will require three tripods. Between the ends will only need two because you will overlap the feedlot panels.
  2. Construct them using the TRIPOD LASHING (a pdf) instructions found above. I turned the T-poles upside down so there wouldn't be any sheep accidents between the sheep and the anchor plates on the T-poles.
  3. Line the tripods up spacing them approximately eight feet apart.
  4. Lay the feedlot panel against it hooking the top square over the center pole of each tripod and overlap each vertical end of the feedlot panel.
  5. If you need a "gate" then don't hook the feedlot panel over the center pole. Just lay it against the tripods and use the double-sided hooks to latch it.